15 Days Internship on ATV Design & Development

THDC Institute Of Hydropower Engineering And Technology, Tehri

Organized By:

THDC Institute Of Hydropower Engineering And Technology

15 June 2016-30 June 2016

Tehri, Uttarakhand

Not Available

Share on Facebook

15 Days Internship on ATV Design & Development

Event Description
I

In this 15 days training program, participants are going to learn the technicallity of designing and manufacturing of an All Terrain Vehicle(ATV). Our manufacturing set up is based on the industry asssembly line so that student can experience the work in Automotive Industry.

  • Statics of automobile engineering:- 1 Day
  • Dynamic Balancing :- 2 Days
  • Designing of Automotive Components :- 2 Days
  • Practical Session for hand on experience:- 2 Days
  • Automotive Development - 6 Days
  • Final Vehicle Assembly - 1 day
  • Automotive Testing & tuning - 1 day

1) Static: - In this part we will be discussing static parts of automobile that how each and every component works.

  • Fundamentals of chassis design
  • Suspension system
  • Braking system.
  • Steering System
  • Engine working and fundamentals
  • Working and Explanation of latest technologies like CRDI engine and many more.

2) Dynamics: - In this part we will be discussing dynamics of automobile in deep and discuss how to balance all the components of a car.

  • Steering dynamics
  • Braking performance triangles
  • Chassis Designing parameters
  • Derivation of drifting equation and turning equation
  • Designing parameters for suspension designing.
  • F.E.A
  • Engine valve timing diagram and engine designing parameters

3) Designing: - this will be the implementation of the things that we will learn in above two parts.

  • Ergonomics Considerations in designing of a car
  • Ride & Handling Consideration in design
  • Suspension lift point designing
  • Chassis designing and Stress analysis of each component
  • Basic as well as complex Surface generation
  • Decaling and rendering of a vehicle
  • Fixtures Generation
  • Sub-component assembly
  • B.O.M (Bill of material)
  • Designing of tire and rim

4) Fabrication: In this part we will be manufacturing the ATV  from very scratch which all  includes.

  • Roll cage profile generation
  • Development of roll cage fixtures
  • Roll cage welding and weld check confirmation
  • Roll cage suspension hard point adjustments
  • Attachment of sub-components holder
  • Engine mounting and it’s tuning.
  • Coupling of engine & transmission.
  • Brake bleeding and installation of braking, steering assembly
  • Final vehicle assembly with all sub-components.
  • Electrical wiring, safety consideration & attachments.
  • Wheel assembly of front and rear drive vehicles, tire pressure calibration, cornering ability test.
  • Tuning & test run of ATV by all the students

 

Visit Fest Website...

Departments That Are Eligible for Participated In this Fest :
  • Mechanical Engineering
Event Categories In This Fest:
  • Workshop

Event Organizers Details

Elite Techno Groups,

faculty convener,

contact no: 9214433665,

email-id: info@elitetechnogroups.com,

Facebook Link